Supports

Hanger Tools

There are a multitude of hanger commands offered in eVolve Mechanical. Whether it's single bearer, multi-service bearer, inserts, or point load calculations.

Features Summary

  • Single service hangers:
    • Fabrication (ITM) based hangers only
      • Supported Patterns
        838
        1238
        1239
        1240
        1241
        1242
        1243
        1244
        1245
        1246
        1247
        1248
        1249
        1250
    • Compatible with Fabrication Runs only.
    • Rule based hanger placement - type, size, and spacing
    • Automatic collision detection and correction
    • Automatic connectivity to structure
    • Insert Placement / Rod Adjustments
    • Automatic Point Placement
  • Mult-Service Bearer:
    • Fabrication (ITM) or Family (RFA) based hanger types
    • Rule-based hanger placement - type, spacing
    • Automatic collision detection and correction
    • Automatic connectivity to structure
    • Insert Placement / Rod Adjustments
    • Automatic Point Placement

Video Summary

Hanger Placement

For performance, it is recommended to run Hanger Placement in a 3D view.

To use the Hanger Placement tool make sure you have fabrication parts already in your model.

  1. Configure the Hanger Settings
  2. Click, the Hanger Placement button
  3. Select the path(s) to place hangers on
  4. Click, Finish in the options bar
  5. Click, Ok to review the support placement results
You can also preselect the pipe or duct prior to clicking on Hanger Placement. Try using the Element Filter

Multi-Service Bearer

To use the Multi Service Bearer tool make sure you have fabrication parts already in your model.

  1. Click, the Multi-Service Bearer button
  2. Select elements from the service to place hangers on
  3. Click, Finish in the options bar
  4. Choose your profile and options then click OK
  5. Pick a direction away from your starting point, this will determine which direction to start placing hangers on your selected path.

Rod Adjustments

To use the Rod Adjustments tool make sure you have fabrication parts already in your model.

  1. Click, the Rod Adjustments button
  2. Select Fabrication (ITM) hangers from the model to adjust
  3. Click, Finish in the options bar
  4. Configure the Hanger Rod Adjustments
  5. Click, Ok to review the support placement results
For more information, please read the following article(s): Hanger Specifications,


How did we do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)